- Out-of-Stock
Pliobarp anti-orators
Continuous, elastic, waterproofing, non-asphalt and high quality coating based on acrylic resins in aqueous dispersion and high solidity pigments.15 l
4 l
C. TECHNIQUES
Colors
C. APPLICATION
Suitable for waterproofing terraces, roofs, roofs, roofs, roofs and party walls. Suitable for renovation of old waterproofing, on all surfaces where it is necessary to prevent moisture and water leaks.
Elastic and waterproof membrane shape
It penetrates deep into cracks and fissures.
Resistant to degradation and aging caused by environmental pollution (anticarbonation).
Applicable in large surfaces without problem of joints.
Resistant to the alkalinity of the substrates, to the weather and to the thermal changes.
Very permeable to the interior moisture of the substrate.
Satin
satin white
red tile satin
satin green
satin grey
Surface preparation
Surfaces should be clean, dry, free of dust, grease, oils, moisture, chipped and consistent. The surface must have sufficient slope for evacuation of rainwater. On hard and dry surfaces and cement mortars without saltpeter: Apply 2 or 3 crossed layers. The first diluted to 25% water, the rest to use or slightly diluted. Restore cracks and fissures with SAND mixture and cover with fiberglass fabric band. On soft surfaces (mortars in poor condition) or with saltpeter, lime and coatings in poor condition: Remove soft, crumbly, chipped and moisture parts. Also remove lime and saltpeters. Seal properly with SELLAFOND (Ref. 1764) and proceed as in the previous case. Recommended minimum thickness 1mm on horizontal surfaces. The effectiveness of waterproofing with PLIOBARP ANTIGOTERAS depends largely on the thickness applied.
Before applying
Application temperature: Higher than 5ºC. Ambient relative humidity: Less than 80% Support humidity: 6%. Support temperature above 5ºC.
How to use
Remove the contents of the container well. Apply with good air renewal, in uniform and well-extended layers. It is advisable to apply a perimeter regatta, both ascending and descending, on the surrounding walls to integrate the waterproofing in the walls and make a more watertight space, avoiding leaks that could be between the fissures of the pavement joints with the walls or walls. Do not apply in foggy or rainy weather. It is not convenient to apply in full sun and with high temperatures of the support.
Storage
Store in a cool place. Do not store open or started containers.
Calculate how much you need:
Total area
m2
nth Layers
Necessary amount
--
Related products
Suitable for waterproofing terraces, roofs, roofs, roofs, roofs and party walls. Suitable for renovation of old waterproofing, on all surfaces where it is necessary to prevent moisture and water leaks.